Hi, I have new Pioneer Kit CY8CKIT-042-BLE-A. I can build any examples and program the BLE PSoC chip without any problem. All is work as expected. Excluding the debugging. When I try to run debug session I get next error:
Debugger exited unexpectedly during run. Encountered error (Target disconnected See output window for more information.)
There was an unhandled error during the debug session. This has forced the debugger to shutdown. Try again.
Output listing of building and debugging :
Programming started for device: 'PSoC 4200 BLE CY8C4248LQ*-BL583'.
Device ID Check
Erasing...
Programming of Flash Starting...
Protecting...
Verify Checksum...
Device 'PSoC 4200 BLE CY8C4248LQ*-BL583' was successfully programmed at 04/22/2017 21:41:24.
Continuing target program
=thread-group-exited,id="i1"
Error: dbg.M0015: Debugger exited unexpectedly during run. Encountered error (Target disconnected See output window for more information.)
CANCEL
At the same time using the same USB cable on the same computer and the same PSoc Creator I do not have any problem with debugging session of other not BLE PSoCs.
I did even turn off sleep mode for using USB port but with zero result.
I am absolutely new in Cypress PSoC so do not have any ideas about resolving this situation.
Thank you for help.